Frequently Asked Questions¶

How do I use my beacon for input shaping?¶

Note

For Simple AF for RPI series you might need to add a [resonance_tester] and [adxl345] section to get this working, because many base printers dont have any input shaper defined!

This just needs a few changes in printer.cfg

You can remove the [adxl345] section

Change the [resonance_tester] accel_chip from adxl345 to beacon

So your [resonance_tester] should look something like this:

[resonance_tester]
accel_chip: beacon
accel_per_hz: 75
probe_points:
   110,110,10

Source: https://docs.beacon3d.com/config/#resonance_tester