Troubleshooting¶
Manual Beacon Serial Device configuration¶
You can run the following command to fix your serial if you forgot to plug your beacon in during the installation or update:
Note
If you run the above and receive an error like:
```
root@K1Max-AF34 /root [#] ~/pellcorp/installer.sh --fix-serial
-sh: /root/pellcorp/installer.sh: not found
```
It means you are on an older version of Simple AF and you should instead use the old style commands:
```
/usr/data/pellcorp/k1/installer.sh --fix-serial
```
'BeaconProbe' object has no attribute '_mcu_freq'¶
This often indicates the beacon was disconnected during homing or some other operation, you need to reboot
On rare occasions this also occurs when the printer gets overloaded, if the error does not clear after a power cycle, try leaving your printer completely powered off for 15 minutes, see if the error clears afterwards. If the error does not clear after doing this, I would be looking for a hardware issue, such as a dodgy cable.